Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have an RV340, and I have two internet links from two different ISPs. I would like to configure load balance and failover, but every time I disconnect WAN1 the WAN2 does not automatically take over. I no longer know what to do to make it wor...
I switched to proxy as suggested, and failover and load balance work, but the DNS error still persists, but in a different way, sometimes I will access a certain page it gives the DNS error, but the next moment the page is reloaded normally, I believ...
By keeping the setting for Failover (1, 2), when I remove the ISP cable on WAN1, I can no longer browse the internet. A DNS error is displayed in the browser (print attached). And when I keep the configuration in Load Balance (1, 1), such error is di...
Looks like it worked, now I have output from both ISPs, end of day I'll test failover.This is my next doubt, if my router is with the load balance at 50% on each link, automatically when a link goes down, the other will take over? Or, for failover to...
