Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We need to create zone between VSAN 110 (Initiator-2) and VSAN 210 (Target-3). [Diagram Attached]Do I need to do anything in fcdomain? Please share your recommendations and action plan to configure the IVR zoning.Please see following command for fcd...
We are using existing Brocade SAN switch and purchased new cisco SAN switch (MDS 9396T). Now we would like to create one fabric across both switch or configure ISL between these.Anyone please guide me, how could we configure ISL between cisco and bro...
@Bhavin Yadav After configure the ISL, we have done the zoning with a host port in BRCD and storage port in MDS but zone member is not showing active and device is not communicating. We have been set interop mode 3 and zone mode Basic in MDS. Also yo...
Hi Yadav, We are currently using BRCD in production and adding MDS as newly purchased. That's why we need to use extended fabric. Right now AG mode for BRCD and NPIV mode for MDS both are disabled.Now, we have putted interop 3 in MDS and by default ...
