Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I created a VPN tunnel from a Cisco 2911 to a sonicwall TZ series. The tunnel shows up and active on both ends but I cannot ping either side nor remote desktop etc. Not sure what I'm missing to allow traffic both directions. Any help as always is app...
I'm throwing in the white flag.. I have an ASA 5508 with ver 9.5. I have setup an AnyConnect Profile, VPN Pool, split tunneling etc. Via AnyConnect VPN software I can connect, authenticate and see internal network just as I should. I can ping google ...
Thank you for the reply. From my understanding by creating the rule that way I was Excluding VPN traffic from NAT Overload. I should create the same ACL list with the IP's switched is what you are saying ? Also remove the deny statement? Example with...
