Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3D2000 sensor that I am able to login to admin using SSH just fine, but I am not able to authenticate via the GUI. I get the following message logging in via HTTPS... "Unable to authorize access. If you continue to have difficulty accessing ...
I am able to login to the GUI. I tried to update the software using the Update tool in the webui but the updates available won't update code older than 5.2
5.4 is available and I will try to update it by re-imaging it.
The software version is 4.7.0.4. Would like to upgrade to the latest version available for my appliance.
I was able to gain access to the GUI. Discovered that the SSH admin account is not the same as the GUI admin account.
Is it possible to reim...
Thanks Pujita for the reply. This is the first time this device is being used and I am trying to set it up for the first time. I am able to login to the admin account using SSH, but I am not able to via the GUI.
