Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have a CW SIMS appliance (aka Cisco 1160) and while performing some patching/upgrading, I'm required to enter the nf oracle user password.If it were the Linux/Windows instalation, this would be user define. On the appliance, pre-installed fro...
As you say, if it's just an inline layer 2 device - a very fancy cable - how is it logical to connect to several vlan's at the same time?Stated on the FOS capabilities in transparent mode, you can only have 2 interfaces - hence the fancy cable termin...
I believe you can't use DHCP through a PIX.The DHCP request has a 0.0.0.0 src add and a 255.255.255.255 dest add.... hence, it's a broadcast, hence, it's not routable, hence, it won't go through the PIX.
I've had that happened once to me. The only way I recovered from that was to uninstall CSPM, re-install CSPM, and then import the .cpm file.One catch though... All logs and history get lost..Hope this helps
