Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to setup port mirroring on a Cisco ASA 5510, but when I try to use the switchport monitor command, that command is not recognized.I've selected what interface I want to configure (conf-if), but the switchport command seems to not be par...
Hi Varun,Please see below.Thanksshow version:Cisco Adaptive Security Appliance Software Version 8.2(1) Device Manager Version 6.2(1)Compiled on Tue 05-May-09 22:45 by buildersSystem image file is "disk0:/asa821-k8.bin"Config file at boot was "startup...
Thanks Varun,Please see the below. This is the output I get when I try to configure the interface. The switchport command is not even being recognized.colo-firewall# conf termcolo-firewall(config)# interface Ethernet 0/3colo-firewall(config-if)# sw...
