Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5505 with a tunnel to a third party network. The tunnel connection comes up fine but I can't get the NAT to work. They are requiring that I send them a specific IP address as the source IP. Here are the specifics:Source Network: 10.10.1...
I have a request to establish a site to site VPN with a customer. While collecting the information I give them our local network subnet which is a private subnet (192.168.5.0). They asked me if I could give them a public address instead. They can not...
Julio,You are correct. I had conflicting commands. I removed all the entries relating to this tunnel from my config and started fresh with the link you provided and everything came up perfectly.Thank you for your help and support.Russ
Hi!The VPN tunnel is passing traffic successfully already, so I believe that crypto map ACL is correctly set up. However it is just not natting the source address properly. The other side is seeing my address of 10.10.1.x instead of 192.168.42.1. is ...
Yes, they have my public IP and I have their information as well. However they cannot work with my local LAN subnet and are asking that I provide them public addresses for the local LAN. Without putting public IP addresses on my internal workstations...
