Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, New to this so go easy on me. Ill attempt to explain everything I have so far. I am using the RV340 VPN behind the ATT Arris BV320 residential gateway. The VPN "WAN" is configured as 192.168.1.xx The LAN1(LAG with 1 and 2) is configured as 10...
When I was examining the routes per your suggestions yesterday and turning off the LAG, I noticed port mirroring was checked. I unchecked this and then saved and restarted the router. Now everything is working as expected.I then went and reset the L...
Ill get through these piece by piece. Heres the two route prints. One using the PPTP server connection and the other using the Client to site connection. Both of the prints are from outside my home.
Additional information if its relevant: On the ARP table screen on the router, both 10.62.0.x hosts are showing up and are assigned to VLAN1 interface. On the wan settings screen, wan 1.2 and 1.2 (Ipv4 connection PPTP and L2TP respectively) are both ...
I copied your message below with my responses. I wanted to make sure I checked off everything so what i understand from your inputs is that your network deployment is as below (my assumption/approximation): PC1----(switch)---LAG----vlan1[RV340]wan1--...
