Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there! I am trying to achieve the following but having trouble. I would like to assign VLAN1 to LAN1 port and VLAN2 to LAN2 port exclusively. I have configured the below. I have connected a PC to LAN2 and received an IP address from VLAN2 as ex...
Hello there! I have connected two ISPs to RV340.ISP1 with PPPoE (Public Dynamic IP) to WAN1 and ISP2 with Static IP (via bridge mode on ONT) on WAN2.WAN1 is set to receive DNS servers from ISP PPPoE DNS servers.ISP1 refreshes public dynamic IP every ...
Hello there! I am new to networking world and started exploration recently with RV340 series as my home router with dual WAN connections (two ISPs). I have connected an access point (AP) to the RV340 for wireless coverage. I would like to have certai...
Cool. DNS request time out errors were reduced by around 90% since I made changes that you have recommended. I will monitor for another day and update this thread with result.Thank you so much for your kind help!!
Sure.1. Applied Google DNS servers for both WAN1 and WAN2 profiles.2. Ensured that DNS Proxy was set for VLAN1 (it's already set to default settings).3. Domain name is already set to "home.arpa' during setup.I have attached screenshots of WAN configu...
I made changes and rebooted the router. However, I am still getting intermittent DNS failures. I tried to access amazon.in from the browser and it throws NXDOMAIN error. I tried to nslookup and ping the domain and it's failed. After few seconds, I wa...
Thank you so much for your prompt advise. Does disabling NSD impacts load balancing configuration as I have enabled load balancing with 50/50% setting?
