Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have been trying to find this information somewhere with no luck. I am new to the IPS modules with Cisco and need to install and configure two AIM-SSM-10 modules in my company's ASA 5520s. What I would like to do is set them up in promiscu...
Luis,Thanks for the reply. You are correct they are not set to alert and that is why I am not seeing anything in the event monitor or reports. Thanks again for the response!Jeff
Hi,I ran this command on a recently enabled AIP-SSM-10 module and it reports several signatures have fired. However, when I run a report or check the event monitor in IME all I see are events for the NetBIOS 5575/0 signature and the ICMP signatures ...
Hi Bob,Thanks for the reply. I do understand the concept of getting the traffic to the IPS modules but my main concern is what happens after. The documentation alludes to the fact that the modules can create ACLs and block traffic, they just can't ...
