Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im new to the ASA5520, I have NAT rules setup andim having some issues allowing RDP traffic from external IP to internal IP. I have one IP/Address that translates fine if you use the FQDN and not the IPif you use the IP it fails.When i Use the packet...
I just tried again outside the network and it finally worked with the IP address. I tested with my iPhone iPad and Laptop via Cellular and it finally connected. Only when inside the network i cant RDP using the public IP only the FQDN which still is ...
I cant RDP any external IP they arnt being translated internally. I can see the counter going up in the ACL list but they wont connect. and I was using the FQDN as an example any IP 30-45 i cannot RDP on even with the rules in place. Only if i use th...
Result of the command: "sh run | i 192.168.1.18"access-list LAN_access_in extended permit tcp host 192.168.1.18 any eq 3389 static (LAN,WAN) 74.203.134.38 192.168.1.18 netmask 255.255.255.255
What would i do to correct this?and why would it let the FQDN pass through?if you rdp remote.ridecitrus.com it connects if you use the ip 74.203.134.37 it doesnt.
