Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Agnelo, Nadeem is correct or use the following command to create a user and a password:username username (name) password (password) this will not encrypt the password unless you configure it. Here is the link show the complete command.http://www.cisc...
Yang was this issue resolved ? if not and if you opened a case please email me the case #. I would suggest you upgrade the both PIXen.There might be some other issues involved. Let me know. you can email at:cihan@cisco.com
PIX Firewall Version 6.3 provides a feature called "Nat Traversal,that is UDP Encapsulation of IPsec Packets.Use the following command to enable NAT-Tisakmp nat-traversal [natkeepalive]default natkeepalives is 20 sec. 10-3600 is the rangeNAT travers...
Hello Arthur make sure sysopt connection permit-l2tp is turned on. here is a good link: http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/config/vpncl11.htm#1009057Cihan Yazicioglu
