Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are adding an ASA 5505 to a network which contains older PIX 501 devices. I have been able to create most of what I need from the Pix onto the 5505 but I am stumed one place in particular: On the Pix there is a rule that alows any inside address...
Thanks for the help. But the intuitive part is where I'm stuck!I go in and choose Security Policy--->Access Rules---->Add. I have entered several other rules just fine here. but when i want to ad a specidic TCP port range??? I'm lost.I see tcp proto...
I never set pix up and I have only used the ADSM interface. Not too familair with CLI although I am currently connected via hyperternmal. Wlk me thru? I feel sort of dumb but I am please I got as far as I have in ADSM by comparing the two interfaces...
