Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Does anyone know if this is possible and how ?static (inside,outside) 1.1.1.1 10.0.0.1static (inside,outside) 1.1.1.2 10.0.0.1 is not allowed.Any other way ?thx Karien
Hello,If I read the documentation, I have to go to ACL Editor/Access Rules, and click "Log matches against this entry"However, my statefull rules are configured under ACL Editor/Firewall Rules, and there I do not have the option "Log matches against ...
Hello,I have 4 security zones defined on my 2611XM - 12.4.15T8 router. The customer defined its security policy as a destination policy to all 4 zones, egfrom 10 hosts/networks to zone1from 20 hosts/networks to zone2, etc,where the hosts/networks ar...
Hello,I want to manage my ASA 8.0.4 through a connection with VPN client. When connected, I can ping the ASA, but trying ssh/asdm gives me a TCP Intercept error. Could it be antispoofing enabled? If yes, should I route the vpn-client range towards th...
Hello,My ASA 8.0.4 is working fine for UDP-over-IPSEC connectinos. However TCP-over-IPSEC over 443 is not working. I did configure port 443 in the ASA. ASDM error I get:(although i am not sure this has anything to do with it) Duplicate phase 2 packet...
Hello,I opened a case@cisco, and firewall accepts are not logged. A workaround you can use is to use audit-trail with parameter map.In future, it will be possible to activate audit-trail generally, while now it still has to be enabled per class-mapCa...
I have only 4 policies, defined on destination zone level.Problem is that I cannot select more then 1 source zone in a policyEgPolicy_1 defines from host_in_zone2, host_in_zone3, ... to zone 1 allow.Policy_2 defines from host_in_zone1, host_in_zone3...
