Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Well unfortunately not a clear way on how to do it with Flexconfig especially that I could not locate for ASA code & commands to start with. It seems ASA does not have them as well.On top of that, Flexconfig can be tricky with TAC & the support as I ...
ok but based on the configuration steps you are mentioning this would apply to all routes, advertised by FTD & recieved if I understood correctly.How to seggregate? On routers we use route-maps to do all of that, here I can only see route-maps used f...
Hey MHM,What I am looking for to be specific is:Use AS path prepending to influence inbound routing into the peer's autonomous system. When using AS Path prepending, we need the firewall to artificially lengthens the AS path for routes it will reciev...
Hey Rob,I am using FMC & I read this document, I could not find where you can manipulate BGP attributes for incoming routes before I pass them to my neighbors, I am not referring to the networks I will advertise where you can set custom attributes. T...
Hey MHM,I checked the flexconfig section of config guide of FMC & could not find any example of how to do it especially that I could not find it on ASA either on how to manipulate BGP route attributtes.BR,
