Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a bit of a problem with my cisco pix 515e firewall.1 - How can i do in the cisco pix the same that i do in linux when i put this comand: ifconfig eth1:1 192.168.1.11 netmask 255.255.255.0 ?Becouse i need to configure multiple ip addresse...
quote: And of course open the traffic destined to 194.189.123.1-194.189.123.10 on the outside ACL.How can i do this? Yes i tought too that static comand was the one i wanted but i was not sure. thanks
I have a a range (imagine 10) of outside ip's (194.168.222.100-110) from my ISP provider and in linux (my actual firewall) i just have all of it configure them like i describe in the main help topic and it all works.Imagine: I have some servers -DMZ ...
