Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have the following situation. We have at work a subnet (192.168.0.0/24) used by all equipment ( wifi devices, mng for switches, printers etc ) . We have a cisco firepower 1010 and a cisco sw. I created on ftd 1010 on interface Ethernet1/5 tw...
I mean is there a way to schedule a reboot if i make the rule and deploy and if something went wrong to reboot and perform a rollback to initial configuration ?
@MHM Cisco World they are in the same Security zone and it does not work.@Rob Ingram i want from wifi to imprimante . But i'm kind off affraid to create the rule to not break somethink...
I will ckeck tomorrow and see if it works. I also have other subnets configured on ethernet 2,3,4 on firepower and i cannot see any rule in nat and i can ping from one subnet to another. This rule is applyed only whem you create subinterfaces or is t...
I`ve attached some pictures to better understand the router configuration.This in my subinterface configuration :and this is subinterface config: I want that from wifi_lan to access imprimante subnet. This is what i have when select add nat ruleI don...
