Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I am trying to do an exercise which topology is: and necessarry config steps are: I am new at computer networks so, I am not sure if I even did the topology correct on the Cisco Packet Tracer. I just did addressing and routing but couldnt do th...
I am trying to do an exercise on the Cisco Packet Tracer which is: and the config steps are:I am just new at Computer Networks and Cisco, so I wanted to ask if I did the all configurations correct or I need to change something on my config? My Packet...
I read all of it so, just adding the following configuration will be enough? Router1(config)# ip nat inside source list 100 interface fastethernet0/0 overloadRouter1(config)# access-list 100 remark -=[Define NAT Service]=-Router1(config)# access-list...
Router0(config)#access-list 120 permit tcp 10.100.0.0 0.0.255.255 host 20.200.0.10 eq 80 with that command aren't we allow only internet http to H1? for the allow any from branch to h1 I don't know the correct command so can you help me about it, ple...
Thank you so much for your help, So I just wanted to ask is the edited configuration now fully correct?I can't be sure because its my first time to configure that many thing together
