Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA5510 which I have setup with subinterfaces on e0/0. I have had one subinterface working for sometime with PAT but I have recently added a new subinterface. I have set both of them to the same security level and I have enabled both same...
I have am trying to setup a network for a video surveillance system. The network is setup in a hub spoke configuration with multicast sources and receivers at all of the spokes. I am using a DMVPN configuration to encrypt tunnels from the spokes to...
Did you create access-lists that allow the desired between the different subinterfaces of different security levels and then assign the access-list using an access-group? If the security level of the source int is lower then the destination int then...
I got it working but I had to turn off nat-control. Once I did that I got it working. With subinterfaces of different security levels. I have yet to test it out on same security level subinterfaces. I plan on working on that this week so I will p...
Thanks j.bourque for the response but I have DMVPN setup and it works. I can get unicast traffic between the spokes but not multicast. Multicast is not an area I know much about. I have tried several things that I have found online but am not sure...
I accidentally submitted the post twice the original had the configs. They are attached below. The routers that I am using are 2821's for the spokes and a 7201 for the hub.
