I would recommend that you use a Non-Root BR to connect to the other side,and then connect the WGB, this will give you a more stable,reliable and scalable solution, over the time and that would really be a good investment from the future perspective.

hi, You need to hold the mode button for about 30 seconds, the light will turn to red and then change to amber and back to green ..... BINGO .. good to go .. my $0.0002 ;-)

Below are some suggestions that will work for you.1 Upgrade the firmware to atleast 12.04 released last week.2 After upgrade you might want to reset the device one to factory defaults if the present firmware is 11.x.3 Try to keep the ethernet...

1. I can see the the newly addedd bridge (10.1.140.5) get Reassociated, Authenticated and then Reassociated again etc. This means that the device is failing to connect properly, data rate settings to yes excpt 1, check if there are CRC on the radio, ...

The best explaination would be chapter 2 in CWNA study guide, it explains the concept end to end.Note : Search Kazaa ," CWNA study guide " size 6.81 mb..... ;-)Cheers!!!Raja