Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Pix 525 configured to work with the 2 built-in ethernet interfaces. I bought 2 Gig ethernet interfaces and I want to install them to replace the 100mb interfaces.My question is about what I will have to do to my Pix configuration so all my a...
Hi, I have a Pix 525 6.1(1) with 2 ethernet interfaces Inside -> lan, private adresses Outside -> InternetI have 3 different public subnets and I need to define static NAT in the 3 subnets that point to internal servers.Can I do that with the Pi...
I installed my new cards last night tried to reconfigure everything. The renaming/swapping of names did gave me the worst headache! but it is in part my fault because I never tried to reload a config from tftp before and I'm not sure I did the right ...
I've tried your solution and it's working perfectly. I had the wrong idea that the Ip address of the outside interface was related to Nat addresses but they are different things.Thanks,Daniel
