Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a pair of ASA 5540s running 8.0(4) 32.A particular interface on the secondary node is shown as Normal (Waiting). I cannot ping the primary node via this interface or vice versa. Each node has the partner node's arp entry for this same inte...
HiWe are running Cisco 4260 with 6.1(2)E3.I would like to confirm that one can use Event Action Filter, to remove "Deny" actions, from every signature? Currently we have edited each individual signature, manually removing the "Deny" action. However,I...
Resolution.There was a route on the FW for the network that the problem interface was connected to. Once we removed the route for this directly connected network, the applicable interface on the primary and secondary node could communicate just fine...
Still waiting on coordination between switch team and Cisco engineer regarding possible switch issues.Creation of a new switchport did not resolve the issue.P
Kusankar,As an add-on to my prior post. The one node interface pair involved with this Normal (Waiting) status (showing only the secondary node), cannot ping each other.I have done captures of the ping tests and can see the pings leaving the applica...
JonThe secondary was able to ping addresses of devices connected to the switch that is also connected to the primary firewall.Kusankar,There is a SSM-4GE card in play. The firmware of the FW 8.0(4)32 and I see that the bug references 8.2(2). I see t...
