Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am not able to join firewall pair in failover.
Pri# sh failover state
State Last Failure Reason Date/TimeThis host - Primary Active NoneOther host - Secondary Failed Comm Failure 19:17:09 UTC May 26 2017
====Configuration State=======Communicat...
Hi,
I want to ensure that if I want to reset my ASA 5500 device to factory default then I just need to do write erase on CLI ?
Do i need to clear flash as well ? Any other commands I need to run ?
Thanks
