Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,My user is experiencing some issue while attempting file transfer with servers that is loadbalance by the CSM.The situation is as, when my user try to copy files that are less than 100mb, the whole process is completed successfully. However if att...
Hi,Facing some problem with DSR configuration hope somebody can help. Below is the config,vlan 711 client ip address 172.18.164.250 255.255.255.0 gateway 172.18.164.1 alias 172.18.164.249 255.255.255.255 vlan 706 server ip address 137.132.15.179 ...
Hi, I'm experiencing a slow response from my web servers via the CSM. After doing a sniffer trace it's show that the Vserver address does not reponse to the intial sync packet of the client but will only reponse to the second sync packets from the cl...
Hi, My setup is as follow, I have 2 CSM in two different 6509 running in active and standby mode and 2 SSLM running also in two different 6509 too.My SSL traffic terminates at my SSLMCurrently my CSM and SSL is working fine but I notice there's this ...
Hi, I have been searching for the MIBS for the CSM and SSL so as to poll useful stats via my MRTG.However, have been searching high and low but to no avail. Does anyone knows. Pls advise. Many thanks
Hi Gilles,I have verify from the trace that the traffic did indeed reach my VLan 711.Yes the CSM is configure in FT mode and the CSM is that I'm configuring is the Active module.I have sent you the trace via e-mail. Please kindly take a look. Thanks ...
Hi Gilles,Sorrry, I'm afraid I have phrase the question incorrectly.What is happening now currently, is that my DSR configuration is not working at all. The client is not getting a reply at all from the server.My sniffer trace show that the CSM is re...
Hi Gilles,If I were to use source IP for stickness for my SSLM, what would happen if the client traffic is from a proxy. Thus will the loadbalancing by my CSM will not be accurate as many clients could be from the same proxy.
Hi Kevin,Thanks for the reply. Have try to powercycle the device but it still does not solve my problem. However just managed to find out the actual problem is that the IOS I'm using have a bug on IP CEF. By turning off and on IP CEF I have managed t...
