Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Weh ave two Cat6513 switches runingg as primary/secondary. and there are one FWSM one each switch runing failover between them. The FWSM version is 2.3(1).It work fine till yesterday. The Primary FWSM get auto-reload again and again. The syslog messa...
I know IDS event view and MC can pull the IDS event from IDS sensors and IDSM. But our company is think to collect all the security message in a syslog server. firewall can send syslog to this server. But for IDS and IDSM 4.1, I can't find a way to s...
Yesterday I install a new 5.0.2 image on IDSM-2 module and works fine. Then I try to upgrade the maintenance partition to version 3. it's popup a message and looks running and not finish for a long time. So I leave it there and go home. Today morning...
Today, the firewall module restart twice with following message:Dec 13 13:10:12.376: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet11/1, changed state to downDec 13 13:10:12.376: reg_invoke_swif_goingdown: GigabitEthernet11/1 -> up, ...
Thanis, Alex. I also found out these informations from Cisco web site. And for SNMP traps on IPS ver5.0, I also think also was too simple compare with IEV or MC. am I right? I hope cisco will improve their software on that. Why IDS can send out syslo...
