Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have a /28 setup in my PIX. The outside interface is xx.185.xxx.xxx The inside interface is 192.168.1.1 I am using NAT to translate my public addresses from the outside to the inside. I have run out of addresses in my /28 so I requested a...
Can I have a /28 and a /24 both allocated into one PIX 515e? My current configuration is setup for the /28 and I would like to keep that address space just as it is and then add the /24 if possbile.Thanks!
I am trying to make a static route from xxx.242.139.164 to 192.168.1.13 and open ports 25 and 443. I am at a loss for what I missed to make this happen. I would also like to have ICMP traffic open or at least echo-reply so I can test the IPs and that...
I do not have a router. My provider assigns me a subnet and I have a PIX as the front line to the internet. I use the PIX to do NAT to my webserver. The /28 that was originally assigned was enough to handle me for the last few years. Now, I need to h...
"do u mean a secondary ip on the same interface?"I currently have a /28 setup in my PIX.The outside interface is xx.185.xxx.xxx The inside interface is 192.168.1.1I am using NAT to translate my public addresses from the outside to the inside. I have ...
Can you please list the commands to this post that one would use to add a second subnet to their PIX? I have searched and searched and have not been able to come up with that information.Thanks!
