Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a webserver connected to the integrated switch on the back of PIX 501 with an IP address on the same subnet as the outside interface. I want to NAT 0 the IP address so that I can have the public IP behind the firewall. I have enabled NAT 0 for...
I understand that the PIX is a layer three device, however, I see specific PIX configs that allow for NAT disabling. For instance, this URL http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094aad.shtml#topic8 specifie...
