Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Have a IE5000 configured with GNSS. Original plan was to use the switch as NTP master. Then found out that it does not support NTP with GNSS - only PTP. My problem now is that I can't find a command to start and configure PTP?Have configured PTP o...
Hi Albert,I see that the IE5000 don't support GNSS sourcing to NTP now. Thanks for that clarification. It is a pity though Support for GNSS to NTP would make the device more useful. Hope that will be implemented in the future.I do need the satellite...
Just so that I understand it correctly:- GNSS can sync to NTPI thought that GNSS only could update PTP?I don't need super exact time (milli, micro or even second) and I don't need PTP. So any sync from GNSS that updates NTP would do.
Hi Albert,Yes, my version was lower than 15.2.8E. So I unstacked one of the switches and now the ptp was there.Have not updated the switches yet. Will do that next.Is it possible to use GNSS on the ie5000 switches in the scenario I outlined above?Ie,...
Hi,There is no command ptp? That's is my problem.switch#sh ptp ?% Unrecognized commandWhat I have is four IE5000. They are set up in two separate stacks. Each stack has GNSS configured and I would like them to be GrandMaster clock. Ideally so they ca...
