Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I am currently working on a vFMC (in a HA pair) with 4x FTD's onboarded (2x 2K FTD's & 2x 1k FTD's).The firewalls are all working fine and the intention is to decommission the 2k's in the near future and just run with the 2x 1k's. My question ...
Hi all,I am currently dealing with a FTD 1010 on version 7.6.4 managed by cdFMC via its external data interface. My issue is, the management0 logical interface is kicking up a fuss because its not receiving any packets but this is to be expected as w...
Afternoon all,
Recently we onboarded an FTD 1010 to cdFMC for cloud management. The management of the FTD (by cdFMC) is via is external data interface.
There was a request to change the external IP address and therefore the routing table to a new ne...
Because of the release date (and EoL date) of this old version of the ASA, I am struggling to obtain the original checksum that Cisco would have provided on this file.
Would anyone have the hash of this file so that I can compare with a file I have ...
Hi all.
We have a customer who is potentially looking to move from a Checkpoint security gateway (OS/Versioning currently unknown) to FMC (again, FTD device currently unknown but it will be managed through FMC).
To proof of concept this, I am looking...
I will try and connect the AI bot to a human engineer and see if they are able to dig any deeper for me. That is one thing we could potentially do. Actualy plug a physical cable into the OOB and see if this resolves anything. Of course we could set u...
Hi Marvin,The management1/1 interface is already merged as the only option I have available on the interface tab of the device is to "Unmerge the management interface" - See pic below:I agree I would also assume this was the fix to my issue but no lu...
Hi Nspasov, Yes that is correct that the data interface is being used for management access to cdFMC NOT the OOB. Unfortunately, we are running 7.6.2, but have just confirmed that running the above command in my solution "> configure network manageme...
Just waiting to attempt a fix by re-issuing the command:> configure network management-data-interfaceAs this will prompt us to reset the data interface, ip address and GATEWAY for management I am hopeful it will clear out the original static route we...
