Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1. can WCS be accessed via a wireless connection.... i am able to access the WLC's via wireless but not the WCS. is there a way?2. howcome when i modify the configuration on the wlc, it is not updated immediately on the wcs? sometimes it takes hours ...
hello experts!!!i'm trying to register a 1500 lap with the airespace 4101.. (is that even possible without the WCS?) but i am unable to get an ip address. i issued a debug command and found out that the lap is talking with the controller. but it is g...
hello experts!!!can traffic pass through 11g to 11a and vice versa. please have a look at the attached drawing and see if any of you can share any practical solution.the idea was to use the APs as repeaters on the three trucks and not to use bridges ...
Hello experts!!!I have a 1200 which has option to support multiple vlans. I have configured vlans on the access point and on the switch. i used vlan 3 and vlan 4. then there is vlan 1 on the AP as the native vlan. if i connect the access point on vla...
hey Richard, thanks for your reply... appreciate it!btw, roaming is one thing,,, ap failover is another...i have 3 WiSM's... and i have only 20 1510 ap's... can the mesh ap's be mixed with the non-mesh ap's in one controller? i plan to reserve/dedica...
hi steprodr!thanks for your reply. it will try this. i really need to get my hands on the AP with tour suggestion. i would like to try G for the outdoor and A for the indoor. however, if i set the role of the APs to bridge modes (1 root and the rest ...
is this setup even possible?btw, the trucks will be mobile all together, most of the time, and all four trucks will be within the range of not more than 300m.
