Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had Cisco configure this device. I needed to go in and open up a few more ports and map them to a new internal IP. This is the first time I have been in the unit since Cisco configured it. When I log in I can only access HOME and MONITORING mode...
I appreciate the response, however I haven't figured out how to modify from the CLI. The alias command is as follows:alias (inside) 192.168.1.3 xxx.xxx.xxx.xxx 255.255.255.255 ( I xxx'd out the actual public IP )This is my first purchase of a Cisco...
