Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a couple FPR-2130s and FPR-2110s. We would like to change our default/dedicated management port to be one of our inside/data ports for simplicity's sake (Management1/1 -> Gig1/2). According to Cisco, you can do this via the CLI or FMC gui, bu...
Marvin,Not sure if this should be a new post but I'll write it here:I'm facing a new issue where only one of the 2130s is using the it's newly assigned data-interface for management traffic. After switching everything over I kept the management port ...
Sorry for the late response; this was our solution. I was under the incorrect assumption that FMC will update FPRs to the most recent version release. However, from what I read on your replies on other threads, it doesn't update past a major version ...
To clarify, we have FMC running on a virtual machine and our Firewalls are physical. If I understand this documentation correctly, I can choose to run the Firewalls with an ASA operating system or run them with our current Threat Defense operating sy...
@Karsten Iwen No, we have plans on using HA in the future but at the moment it is not configured on any devices. @balaji.bandi On our end, the "Management Only" checkbox is greyed out on our 2110s and 2130s. Additionally, we don't see the "FMC Access...
