About ChrisNye

ChrisNye · 03-21-2023

I am unable to login to the FDM GUI ISA3000 FTD 7.0.1 using the local admin credentials after initial setup on the CLI. I can access the the FDM landing page through the web browser but get a red x above the login prompt after entering the admin cred...

ChrisNye · 01-23-2023

I am using FTDv version 7.3 FDM to configure policy-based VPN using a Hub and Spoke topology in a lab environment. The spoke's VPN profile uses two different outside interfaces as it's source (outside1 & outside2). Each spoke dynamically pulls it's o...

ChrisNye · 09-01-2023

I ended up re-imaging the FTD to ASA 9.19(1). I am using DVTI at the Hubs and VTIs at the spokes w/ EIGRP for Load balancing/failover. Thank you for your suggestion.

ChrisNye · 03-23-2023

I ended up re-imaging the device to a later version to resolve the issue.

ChrisNye · 01-26-2023

Thank you for your clarification and suggestion. The FTD doesn't allow configuration of traffic zones on interfaces used for VTI's when managed through the Firepower Device Manager (FDM). That configuration option is only available through FMC manage...

ChrisNye · 01-24-2023

Thank you for your response. The document you linked to states that ECMP Traffic Zones cannot contain “Interfaces used for site-to-site VPN or remote access VPN connections.”Your explanation of the FTDv interfaces makes sense. I was using it FTDv to ...

Member Since	‎01-23-2023 09:25 AM
Date Last Visited	‎11-02-2023 12:58 PM
Posts	6

User Statistics

User Activity

Can't login to FTD GUI

FTD IP SLA using Dynamic Default Routes

Re: FTD IP SLA using Dynamic Default Routes

Re: Can't login to FTD GUI

Re: FTD IP SLA using Dynamic Default Routes

Re: FTD IP SLA using Dynamic Default Routes