Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On a PIX 515 with a 6.3(4) OS:I removed a NAT Static and added a PAT static with the same local address but a different global address. I then did a "CLEAR XLATE LOCAL XXX" where XXX is the local address in the Static. "Show XLATE" displayed the new ...
No. The new new IP and port were not already assigned. In fact, a show XLATE revealed that the new mapping was in the XLATE table and there were incomming "hits" showing in the access-list.Any ideas would be greatly appreciated.
