Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don't seem to be able to configure an SMTP port forwarding rule on the PIX506 device manager.Can anyone tell me how to do this via PDM.Is there an easier way to do it via CLI and how can I test the forwarding rule?Thanks in advance
We have a pix506e device connected to a router via ethernet. We have a mail server on the internal network (192.168.1.100) and the PIX is acting as a DHCP for the internal network. the PIX gets an external address from the DHCP on the router (192.168...
I'm not sure about the PIX, How do I check?the router is, as the network can't see the internet if it doesn't.i have a rule on the router (which isn't a cisco router) that allows all SMTP traffic through. the logs seem to be confirming this.Wed, 2006...
thanks.I have set the rules through CLi and they seem to be accepted OK.Are there any problems with having a router as the connection equipment that is performing NAT.The rules on the router are set so that they allow all traffic.I can access the int...
I know I didn't start this thread but I have a very similiar problem, so I apologise for hijacking this, hope no one is offended. I am trying to do the same thing route smtp traffic through to an exchange server behind a PIX506 and a router. the rout...
thanks,Should have said that the router isn't a cisco.But that bit seems to be working allright logs show the traffic being passed to PIX outside interface.configs are as follows:PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 autonamei...
