Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I curious if a asa (v7.0.7) can route traffic in and out sub interfaces. Please see the attached diagram. Our ISP is handing off a 802.1q tagged ethernet connection to us. One vlan is for internet connectivity and the other is for a private lan. ...
I think I'm all set now. Not sure what was going on. The strange thing is I never see a entry in the xlate table for a 172.31.253.x address to my pat address though everything is working just fine. Can anyone explain this?
I found I had a no nat statement on the interface in question. Now I'd like to put a ACL on the interface to restrict both inbound and outbound traffic but I'm having a problem getting to work as I'd expect.
