Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys, I have a topology like aboveI'm trying co config HSRP for two L3 SWI think my HSRP config is fine, i check with "show standby brief" and see one active, one standbyBoth L3 SW enable ip routing, default route to 192.168.5.254 with e0/0 acc...
At first, the topology have just 1 L3SW (R1) connect to Router, and i want connect both L3SW to Router in case if connection between R1 and Router broke. At first R2 is running as L2SW (ip routing not enable) so i turn it on routing and connect R2 to...
I already create VLAN10 (192.168.10.0/24) for the clientAnd on Router i create a static route: 192.168.0.0/16 with gateway is 192.168.5.253 (VIP).But nothing changes.
The Router have multiple WAN and LAN port, and i set all the LAN port using LAN1 with subnet: 192.168.5.0/24As the topology, i connect two L3SW to two LAN port on Router.And I made a static route on Router to subnet 192.168.0.0/16 with gateway is 192...
