Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 3 Tunnels and I am unable to get all 3 up at the same time. If I try to use Tunnel source loopback on any of them the tunnel will not come up. It will only come up as tunnel source physical interface like Gi0/0. Additionally I tried connect...
Everything I read on keyring with vrf is related to using vrf for more of a mpls network and using the endpoints in the vrf itself. I was mainly focused on vrf lite with vpn. I suppose vrf e2e inside as a souce would be better. I also see crypt map ...
I found out the issue. Tunnel source loopback ONLY works if the destination is also a loopback ip address and all loopbacks are routed. I advertised 3 loopbacks on each router and mapped source and destination and dest said loopback example 4.4.4.4...
A set up with a Tunnel with a VRF and then using a tunnel source as a loopback is about as general issue as I can get without all the other fluff later on like tunnel protection ipsec stuff. A basic tunnel will not work if in a VRF if I am sourcing...
Here is the Tunnel config and output. If you need entire topology and config for all devices for the transit and end to end, I would need to sanitize some of the node names. changed VRF name for demo sake. Again Tunnel source doesn't work at all wi...
