Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team:Am having a hard time to understand what went wrong. The site to site was working but I notice the output below: FAB#show crypto ikev2 saIPv4 Crypto IKEv2 SATunnel-id Local Remote fvrf/ivrf Status1 160.238.160.18/500 200.32.190.146/500 none/n...
Hi Team,So currently I have a FTD that I manage via FDM. Am trying to access an internal host from the outside via port 8888 but internally it should translate back to ssh (22). Screenshot is my nat rule. Not sure if am doing something wrong and what...
Hi All,I have been having a hard time to integrate ISE with my Cisco FTD since most of the articles covers using the FMC. For my FTD device I am using FDM not FMC. What I am trying to accomplish is to block web whatsapps by user usage. I have been ab...
I did the changes but nothing stillFABSPLRT#ping 192.168.1.251 source vlan20Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 192.168.1.251, timeout is 2 seconds:Packet sent with a source address of 10.20.20.1...*Aug 9 21:12:30.369: IKE...
