Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If you have restricted license then you can't use more then three interfaces.The output of show version will tell you which kind of license you have.http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_data_sheet09186a00800b0d85.htmlI hope ...
If you go to the following link it has some really good tech tips on pix firewall.http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Hardware:PIX&s=Software_Configuration#Software_Samples_and_TipsPort redirected (static nat) is used for inbou...
Hi Marc,You don't need a router, pix can act as dhcp client.ip add outside dhcp setroutethe above command will allow you to get the ip address for outside interface as well as the default gateway for the pix.I hope this helps.Syed
Pix doesn't map the ports, it can only redirect it, so the following command won't work. static (inside, outside) tcp interface 80 10.1.1.15 2001 other then that it should work the way you have configured unless there is a software bug. I suggest tha...
1) Pix will only proxy arp if you have static, nat or alias commands configured. I suggest that you check your config for overlapping addresses.2) If the host A already has a MAC address of host B It will not send packets to the default gateway, unle...
