Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Afternoon - I am transitioning from ASA 5505 to FRP-1010 ASA. I have migrated most of my configuration but my OSPF commands to add to VLAN are not taking, from CLI or ASDM. What am I missing?OSPF Config:router ospf 32router-id 10.128.121.254ne...
Thank you for your help. Sorry I miscopied the wrong input. See below. AZR-NOC-FPR-1010(config)# int vlan32AZR-NOC-FPR-1010(config-if)# ip osAZR-NOC-FPR-1010(config-if)# ip ospf priority 0^ERROR: % Invalid input detected at '^' marker.AZR-NOC-FPR-1...
AZR-NOC-FPR-1010(config)# int vlan32AZR-NOC-FPR-1010(config-if)# ip osAZR-NOC-FPR-1010(config-if)# ip ospf priority 0^ERROR: % Invalid input detected at '^' marker.AZR-NOC-FPR-1010(config-if)#
Apologies, noticed I copied the wrong syntax. Same outcome.AZR-NOC-FPR-1010# int vlan32^ERROR: % Invalid input detected at '^' marker.AZR-NOC-FPR-1010# ip ospf authentication message-digest^ERROR: % Invalid input detected at '^' marker.AZR-NOC-FPR-1...
