Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I inherited an ASA 5510 and have very limited experience with ACLs. There are two main problems I'm running into:1. We have a multifunction device that sends scans as email but they never go out. I attempted to make an access list to allow SMTP...
Hi,Yes everything internally works correctly. I wanted to be able to RDP to the site when I'm not here but I have other ways of connecting and would rather not needlessly overcomplicate things.Thanks for your help, I greatly appreciate it.EG
I ran both the tests and they came back allowing access. The problem I'm having is coming from outside in. When I attempt to RDP external it doesn't connect. What do I need to make for the external network, if any, so that it should work?
Hi,Yes it is targeting the ASA interface IP. I'm not sure that everything is configured correctly since I just took this over and am learning on the fly.Attached is the running config. Thanks again for the help.
Thanks for replying. Sorry it took so long to get back to you. The information you asked for is below.Source interface: Ethernet 0/1Source IP: 209.118.65.194Destination Interface: Ethernet 0/0Destination IP: 172.16.0.1Result of the command: "pa...
