About pcasado

pcasado · 03-23-2025

problem with a 9372TX-E that was working with no error before upgrading from 9.3.7 to 9.3.14, it restart all the time on final stage with error "switch %$ VDC-1 %$ %MODULE-2-MOD_DIAG_FAIL: Module 1 (Serial number: SAL2023RCXL) reported failure on por...

pcasado · 03-25-2025

No solution, just send to e-waste...

pcasado · 03-24-2025

I tried to boot from usb1:, usb2: and even tftp:, but it doesn't fully boot an image, at the moment that it check the modules it display the error and it reload. if it boot and at least stay on, I would at least re-check with the EPLD images. I did r...

pcasado · 03-24-2025

Thanks, I tried all that already, such steps are good for "recovering" from landing to the loader (GRUB) every time it reboots, in my case, I can't do anything at all that takes more than 30 secs, as when I break the startup to login, in the backgrou...

pcasado · 03-24-2025

thanks @Mark Elsen for the reply, I break the start checkup, then I login (admin/<blank>), it goes on, but then, in around 30 secs. it display the error (device failure) and it automatically restart, leaving me the loop back on the loader> prompt..

Member Since	‎07-09-2023 02:12 AM
Date Last Visited	‎11-25-2025 02:03 PM
Posts	5

User Statistics

User Activity

Cisco Nexus C9372TX-E device failure after NXOS update

Re: Cisco Nexus C9372TX-E device failure after NXOS update

Re: Cisco Nexus C9372TX-E device failure after NXOS update

Re: Cisco Nexus C9372TX-E device failure after NXOS update

Re: Cisco Nexus C9372TX-E device failure after NXOS update