Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just installed the ASA 5506X with firepower
ASA Ver 9.6
Firepower ver 5.4.1-211
ASDM 7.6
I used the setup wiz in the ASDM to configure interfaces and Firepower management interface. All seem to work well and I have firepower up and running with IP...
Thanks so much. Turns out I had to reboot the ASA before the DNS resolution started working after the updates to DNS. I am now able to down load updates.
Again Thanks for your help
My setup is as follows
Outside SL 0 is connected to ISP
Inside SL 100 is 192.168.10.2 and Firpower module is 192.168.10.4 using 192.168.10.2 as default GW
I also have a DMZ SL 50 with 192.168.15.0/24
All networks are NATing out and clients on both in...
Thanks that was very helpful. I now show DNS servers in the resolv.conf and nslookup resolves now. I still am not getting updates however. When I go to updates in the ASA Firepower configuration and pick the rules tab for example then pick "Download ...
