Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a question if someone can help me with that please, I have FTD configured in Active standby and managed by FMC. These FTDs are going in to an upstream nexus switch. I am using RFC1918 addresses between the outside interface of FTD and SVI...
no it was not a type, i switched it on for testing and i switched it off after you highlighted this. But it did not make a difference, I power cycle my FTDs and now it is working, it is getting the default route now thanks for help and bearing up w...
This is the ask, I have tried this on ASA in my lab and it accepts the e2 default route but the FTD in the live environment does not accept the default route and this is going to mess up my design.
