Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to reset the data inside interface? After a reimage to "Cisco-ftd-fp1k.7.2.8-25.SPA" the setup wizard was bypassed (not by me) and the 1010 got configured to use "Use Unique Gateways for the Management Interface". This was an incorrect...
After two weeks working a case with TAC, It has been explained to me that "IPS Software Sensors" shown in the ASDM's "Product Licensing" area is a "Dunsel" entry. In addition to that, the screenshot attachment that shows I have (0) quantity "IPS Sens...
Hi... I performed the following upgraded to the ASA FirePower (module) application and it seems the ASDM Launcher stuck at 28% into authentication. Below are the two patch files I used for the upgrade. The pre-install completed successfully however ...
Hi balaji.bandi, I have been doing some thinking. Maybe you can check my thoughts? In the FDM In order to switch from "Use Unique Gateways for the Management Interface". to "Use the Data Interfaces as the Gateway without returning a bad address". Wou...
After a reimage to "Cisco-ftd-fp1k.7.2.8-25.SPA" the setup wizard was bypassed (not by me) and the 1010 got configured to use "Use Unique Gateways for the Management Interface". This was an incorrect configuration, and I couldn't stop the process in ...
