Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to config Static routing in asa 5510 firewall using IPV6 address.I have config the following ipv6 based on the simple network in order to generate traffic flow in Firewall accessing all the host and server.I am able to ping in ASA 1) ...
Sir any comments or suggestions to correct my steps or any scope you can generate a ICMPv6 DDoS attack data set and kindly share based on the above network diagram.
Is there any scope for any one who can at least direct me to ICMPv6 DDoS attacks data sets. I have tried my best to check from the openly available and could find only IPV4 DDoS attacks but not the ICMPv6 DDoS attacks data sets. I just need only 10-1...
i Sir, I have tried to use the command switchport trunk in GigabitEthernet0/1 and interface mode i.e.ciscoasa(config)# interface GigabitEthernet0/1 ciscoasa(config-if)# switchport mode trunk ^Error: % invalid inp...
