Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
At the switch, you could use the << show int fc1/x transceiver details >> command which would give you the programmed part-number. The DSS... sticker is likely the Cisco partnumber. It's perhaps a good habit to do at least once execute a full "show ...
Remove them manually in Conft mode use "no flow" commands, use the wizard to create new flows and ticking the box, delete old-flows.Alternatively (probably what you want), enter FabricManager.Select fabric tree, go to the Flow_Statistics tree entry (...
If you reload / re-insert the blade, it will usually automatically check and optionally (re)place the module firmware version.Alternatively, use privileged admin command:<< reload module x force-dnld >>where 'x' is the involved module.I presume, the ...
I would add an full qualifying explicit IP route for the 10.1.25.0/24 network used for the FCIP connection. By this controlling the right (outgoing/gateway) interface is used.Question: Your ping, did it use an explicit source address to select the GE...
Obviously s/he can get or have them and me also as eBay-like-afterMarkets has lots of them :) Serious, why no trying it. Equipment will not go broke. To my latest memory of access experiment, 1/2Gbics will work in 1Gbic only.Goodluck and let us know.
