Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been asked to a PIX 501 between our lan and a database server (on the same lan) to allow access to certain ports.I have configured it with two test PCs and set up a rule to allow RDP but I cannot get access.I have attached the running config a...
I posted recenly because i was unable to connect via VPN i received very helpful replies and that issue is resolved however now that i cann connect via VPN it is painfully slow. something as simple as connecting to a ahre on a server takes forever or...
I have ran the VPN wizard on my PIX 501 choosing the option to connect with Cisco VPN client 3 or higher. i am using client version 5.0.04 with the group name, IP Address of the PIX and the username /password set. the rest are defaults. when i try to...
Hi Jon,Thankis for the quick reply,I had to assign the 192.168.1.0.1 to outside interface as the ouside and inside interface cannot have an address in the same IP range.To complete the test I need to have 192.168.1.2 connect to 192.168.1.152 via the ...
UPDATE###I noticed on closer inspection that the stateful firewall on the Cisco VPN client is blocking my attempts to connect to the servers that i have explicitly disabled natting to on the PIX. if i switch the firewall off there is no data in the l...
Hi,Thanks for the prompt response.I added the line you suggested and still could not connect. I have attached the log from the Client after that connection attempt.Regards,James
