Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having problem with my asa 5510 forwarding outside requests to the appropriate inside servers. I included a test config file. I am replacing an older pix that is going bad and copied a lot of the information into the new config as far as acces...
If you cannot telnet to the mail server address from the outside on port 25 check and see if your outside ACE's are getting any hits, if not you may need to reset any routing device in front of the ASA if you have control over it. That way it can bui...
Seems like restarting the Router in front of the ASA worked. You think it wasn't building arp tables properly or what? I'm glad it was something that simple but feel kinda dumb, haha
Sounds good guys, I will test these things tomorrow during downtime and get backAlso there is a router between the cloud and the asa, It is in our rack but I don't have access to it, this was all set up before I started and there is very little docum...
My 10.10.'s represent my public addresses in the test config I posted. Everything looks to be set up correct but im not getting any hits at all on my incoming ACL's. I slowly add more and more less secure acls hoping I will see something but nothin...
